News For This Month: Cutting

Top Benefits of Waterjet Cutting

Whether you are new to the technology or are a veteran in it, you need to be well aware of the benefits, as many as they are, of using waterjet cutting. In this post, we will be taking a look at some of the benefits of waterjet cutting which when well understood will help you make an informed decision going forward in your business.

First and foremost, one thing that needs to be well understood going forward is that there are two kinds of waterjet cutting techniques and these are the pure waterjet cutting and the abrasive waterjet cutting techniques. For the pure waterjet cutting technique, this is that which basically sees the use of nothing but the water streams for the cutting and is most commonly applied for the cutting of the soft materials such as foam and paper. Looking at abrasive cutting, this that which involves the addition of an abrasive to the water stream for the cutting. With the addition of these granular abrasives, there will be accelerated the power of the cutting and as well the speed which makes the cutting even of the hard materials like ceramics and metals a lot easier.

Read on and see some of the benefits that come with waterjet cutting as have been highlighted below to boost your knowhow on this technology and as such make better decisions for your needs.

First and foremost, waterjet cutting is applicable on a wide range of materials, be it on the composites, metals, plastics, glass, rubber, stone or rock, and ceramics too. By the way, where you even add the granular abrasives, you will see a waterjet cutting technology cut materials as thick as 200mm.

The other worthy benefit of the waterjet cutting technique is in the fact that it results in such cuts that have no heat affected areas. This is as a result of the cold cutting method applied in it which as well has the benefit of increasing the operator’s safety as there are no chances of burns. Over and above this, the cold cutting technology as well is as good as it helps you limit the cases of material distortion as a result of the fact that the heat is bypassed and as such so good for the cutting of such materials like metals which may be affected by such heats on them while being worked on for cutting. With waterjet cuts, you end up with such smooth and burr-free cuts.

The Best Advice on Parts I’ve found

Practical and Helpful Tips: Equipment